About The Network Function - Pioneer DEH-80PRS Operation Manual

Operating this unit
# You cannot select Auto TA if auto TA and EQ
has not been carried out. In this case,
Please set Auto TA appears.
Adjusting time alignment
The distance between the selected position
and each speaker can be adjusted.
! An adjusted time alignment is memorized
in Custom.
1 Use M.C. to select TA 1.
Refer to Introduction of audio adjustments on
page 19.
2 Press M.C. to select a unit of distance.
(cm) (centimeter)—(inch) (inch)
3 Press /DISP to display the upper tier.
4 Use M.C. to select TA2.
Refer to Introduction of audio adjustments on
page 19.
# Can't Adjust TA. Set POS. FL/FR appears
when neither Front Left nor Front Right is se-
lected in the position selector mode (POSI).
# When selecting OFF in TA1, you cannot
switch to TA2.
5 Turn M.C. to select the speaker to be
adjusted.
3-way network mode
High L (high-range left)—High R (high-range
right)—Mid L (middle-range left)—Mid R
(middle-range right)—Low L (low-range left)—
Low R (low-range right)
Standard mode
Front L (front left)—Front R (front right)—
Rear R (rear right)—Rear L (rear left)—
SubW. L (subwoofer left)—SubW. R (subwoo-
fer right)
# You cannot select SubW. L and SubW. R
when the subwoofer output is off.
6 Turn LEVER to adjust the distance be-
tween the selected speaker and the listen-
ing position.
400.0cm to 0.0cm is displayed as the distance
is increased or decreased, if you have selected
centimeters ((cm)).
160inch to 0inch is displayed as the distance
is increased or decreased, if you have selected
inches ((inch)).
# You can adjust the distance for the other
speakers in the same way.
7 Press BAND/ to cancel the time align-
ment mode.

About the network function

The network function lets you divide the audio
signal into different frequency bands, and
then reproduce each of them through sepa-
rate speaker units.
You can then make precise adjustments to the
reproduced frequency band (with a low-pass
filter or high-pass filter), level, phase and other
parameters to match the characteristics of
each speaker unit.
Section
02
21
En