Toyota Land Cruiser 2007 Manual page 201

19C516
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate,
identify if your garage transmitter is of
the "Rolling Code" type. Press and hold
R
the programmed HomeLink
The garage door has the rolling code
feature if the indicator light (on the
R
HomeLink ) flashes rapidly and then
remains lit after 2 seconds.
garage transmitter is the "Rolling Code"
type, proceed to the heading "Program-
ming a rolling code system".
6. Repeat steps 2 through 5 for each re-
R
maining HomeLink
another device.
Programming a rolling code system
If your device is
equipped, it is necessary
steps 1 through 4 under the heading
"Programming the HomeLink
proceeding with the steps listed below.
R
by
button.
If your
1. Locate the "training" button on the ceil-
button to program ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door opener.
"Rolling Code"
guide supplied by
to follow
opener manufacturer for the location of
this "training" button.
R
" before
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 sec-
onds in which to initiate step 3 below.
3. Press and release the vehicle's pro-
grammed
The garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door open-
er motor should now recognize the
HomeLink
the garage door up/down.
4. Repeat steps 1 through 3 for each re-
maining HomeLink
another rolling code system.
Refer to the owner's
the garage door
R
HomeLink button twice.
R
unit and be able activate
R
button to program
221