Errors Signalised Acoustically; Conformity Assessment (Legalization) - ELZAB Prima 2 User Manual

Function non accessible at the moment.
Bá dna warto ü wprowadzonej danej.
Scale blocked. Report the fault to the service.
A/C converter error. You should remove the cause of interferences.
EEPROM memory error. Report the fault to the service.
FLASH memory error. The scale returns to factory settings.
Communication error on the SPI bus. Report the fault to the service.
Initiation of the FLASH memory after it was cleared up. Report the fault to the service.

7.2. Errors signalised acoustically

If the acoustic signal occurs when the display is switched off it means that:
Three consecutive single signals
(*---------,*---------,*---------)
Three consecutive double signals
(-*-*------,-*-*------,-*-*------)
Three consecutive quadruple signals
(
-*-*-*-*--,-*-*-*-*--,-*-*-*-*--

8. Conformity assessment (legalization)

Scales provided by ELZAB have undergone the conformity assessment procedure (legalization)
and are ready for use in the trade settlements in accordance with applicable law. Confirmations of
compliance with the above requirements are as follows:
1. large letter M on a green background placed on the scale nameplate,
2. set of metrological control characteristics, placed in accordance with the drawings set out
below,
3. compliance of the markup number placed on the nameplate with the markup number stored
in the non-volatile memory of the scale.
The markup number stored in the non-volatile memory of the scale can be checked any time, as
follows:
1. The scale should be in the weighing mode and indicate the weight
2. Press the
3. Pressing the
4. Press the
memory of the scale, e.g.:
ELZAB S.A.
USB interface communication error. The most common reason
of the error is lack of the virtual serial port driver installed on the
computer. This error is signalised after turning on the scale.
To low power voltage (< 4,5V). Error signalized during
switching on or rest of the scale.
To high power voltage (> 5,5V). Error signalized during
)
switching on or rest of the scale.
key and hold it until the displays shows the scale menu:
or key go to the menu item:
key. The display will show the markup number stored in the non-volatile
kg.
.
User Manual PRIMA 2 scale
.
25