Drone Swerves Or Moves Erratically Before Taking Off; Fcc Information; Limited Warranty - Radio Shack Zeraxa 2.0 User Manual

Auto-hovering camera drone
Table of Contents

Advertisement

Drone swerves or moves erratically before taking off

• The gyroscope inside your drone needs calibrating: Do the following:
1. Switch on and pair your drone with the remote control set to
ON position.
2. Move the throttle all the way down and the steering forward
at the same time. Hold this position until the drone LED eyes
start to blink rapidly. Then release the controls.
3. The drone LED eyes light steadily. Calibration is successfully
completed, and you are now ready for takeoff.
• See "Trim Your Drone" to further fine tune and improve control of your drone
after calibration, if necessary.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your
equipment. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

Limited Warranty

Go to www.radioshack.com/help for details.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
Complies with the European Union's "Restriction of
Hazardous Substances Directive," which protects
the environment by restricting specific hazardous
materials and products.
© 2016 General Wireless Operations Inc.
All rights reserved. RadioShack is a registered trademark
used by General Wireless Operations Inc. dba RadioShack
www.radioshack.com
14
Printed
12A16
in China
6001434

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents