Table of Contents
Advertisement
install Batteries in the remote Control
1. On the remote control, set the ON/OFF switch to OFF.
2. Use a screwdriver to open the twin battery compartments. Then
insert four AA batteries (not included), matching the polarities (+
and –) marked inside. Replace the cover.
Note: If the remote control's LED flashes during use, the batteries
are low and should be replaced.
Battery Notes
• Dispose of old batteries promptly and properly. Do not burn or bury them.
Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of different capacities.
• Remove batteries during longer storage periods. Batteries can leak
chemicals that can damage electronic parts.
Lithium Battery Notes
• Follow the instructions for charging. Do not charge longer than
recommended. Unplug the charging cable when the drone is charged.
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• If the electrolyte in the cells should get on your skin, thoroughly wash
with soap and water. If in the eyes, rinse thoroughly with cool water.
Immediately seek medical attention.
• Do not attempt to charge or operate damaged toys.
4
Charge the drone
Your drone uses
a built-in
lithium polymer battery for power.
1. Set the drone's ON/OFF switch to OFF.
2.
Connect the included USB charging cable to the drone's CHG
jack and a USB power source (such as a laptop). The LED inside
the USB connector lights red during charging, and turns off when
charging is complete.
A full charge takes about
of flight time.
3. After charging, unplug the charging cable.
CaUtiON
• Use only the included USB charging cable to charge the drone's
battery. Other cables may damage the drone.
• Always let the drone battery cool before recharging.
CHG
55 minutes, and gives up to 7
5
ON/OFF
minutes
Hide quick links:
Advertisement
Table of Contents
