Control And Status Registers; Control And Status Registers For Basic Camera Operation - Basler A640F User Manual

4.4.2 Control and Status Registers

The base address for all camera control and status registers is:
Bus ID, Node ID, FFFF F0F0 0000
In each control and status register description, an "Offset from the Base Address" is provided. This
a byte offset from the above base address. The address of a control and status register equals
the above base address plus the indicated offset.
Values are stated in decimal format except when marked 0x. Values marked as 0x (e.g., 0x123)
are in hexadecimal format. Bit 0 in each register is the most significant bit.

4.4.2.1 Control and Status Registers for Basic Camera Operation

Register Name:
Offset from Base Address:
Field
Frame Rate /
Revision
---
Register Name:
Offset from Base Address:
Field
Mode
---
BASLER A640
f
DRAFT
Current Video Frame Rate / Revision
0x600
Bit Description
0 ... 2 If a camera is set for video Format 0, 1 or 2, this field sets the current
video frame rate.
0 = frame rate 0
1 = frame rate 1
2 = frame rate 2
3 = frame rate 3
Default = 0 on all A640f cameras
Check Sections
rates supported.
If the camera is set for Format 7, the setting in this field is ignored.
If the camera is set for Format 6, this field sets the current revision.
(A640f cameras do not support Format 6.)
3 ... 31 Reserved
Current Video Mode
0x604
Bit Description
0 ... 2 This field sets the current video mode.
0 = mode 0
1 = mode 1
2 = mode 2
3 = mode 3
Default = 0 on all A640f cameras
Check Sections
by A640f cameras.
3 ... 31 Reserved
4 = frame rate 4
5 = frame rate 5
6 = frame rate 6
7 = frame rate 7
3.9.1 and 3.10.1 to determine the standard frame
4 = mode 4
5 = mode 5
6 = mode 6
7 = mode 7
3.9 and 3.10 to determine the video modes supported
Configuring the Camera
4-23