Buttonhole Lever - Janome Skyline s7 Service Manual

Buttonhole lever

Buttonhole
lever guide
Setscrew
Buttonhole lever
Buttonhole foot (R)
Mechanical adjustment
Hexagonal
Buttonhole
socket screw
lever guide
⇔
Setscrew
Hexagonal socket screw
1.6 mm
Stopper
Slider
1. Turn the power switch ON while pressing the Start/
Stop button and the Reverse stitch button. The LCD
shows the Factory Setting Mode. Press "BH Sensor"
key.
2. Open the face cover. Lower the Buttonhole lever.
Loosen the setscrew on the buttonhole lever guide.
Move the buttonhole lever guide to the left to adjust
the position. Tighten the setscrew when the indication
below "BH Sen" changes from "H" to "L".
3. Attach the automatic buttonhole foot (R). Insert a 1.6
mm thick spacer between the stopper and slider of the
foot.
4. Press the presser foot lifter button to lower the
automatic buttonhole foot (R). Lower the buttonhole
lever.
5. Turn the hexagonal socket screw counterclockwise
(use an Allen wrench of 2 mm width across flats) until
the indication below "BH Sen" shows "H".
Turn the setscrew slowly clockwise until the
indication changes to "L".
28