Dell Z9000 Quick Start Manual page 23

To tag interfaces, follow these steps:
Step Task
Access the
1
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
Enable an interface to
2
include the IEEE
802.1Q tag header.
To move untagged interfaces from the Default VLAN to another VLAN, use the
untagged command.
To move untagged interfaces, follow these steps:
Step Task
Access the
1
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
Configure an interface
2
as untagged. This
command is available
only in VLAN
interfaces.
Assign an IP Address to a VLAN
NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,
is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command.
To assign an IP address to a VLAN, follow this step:
Task
Configure an IP address
and mask on the interface.
Command Syntax
interface vlan vlan-id
tagged interface
Command Syntax
interface vlan vlan-id
untagged interface
Command Syntax
ip address ip-address mask
[secondary]
Command Mode
CONFIGURATION
INTERFACE
Command Mode
CONFIGURATION
INTERFACE
Command Mode
INTERFACE
Installing the Software
21