Installation - Pyle PWR95S User Manual

Waterproof bluetooth solar panel floating speaker system
Hide thumbs Also See for PWR95S:
Table of Contents

Advertisement

Battery Charging
The unit incorporated a built-in rechargeable battery. A battery compartment located at bottom
of the unit.
(1) Unscrew the Bottom cap counter-clockwise and open it.
(2) Connect the micro USB plug of the USB cable to the micro USB connector of the unit.
Red indicator lights up when charging the unit, light turns off when it's full charged.
Note:
Battery Life: 4 Hours (Charge Time: 8 Hours)
Please use standard DC 5V 1000mA adapter and supplied USB cable to charge. Or, connect
USB cable to computer to charge. If the adapter power rating is too small, it may cause the unit
not to be fully charged or have short battery running time.
Warnings:
- Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- Be sure that the battery is installed correctly. Wrong polarity may damage the unit.
- Only battery of the same or equivalent type as recommend are to be used.
- If the unit is not to be used for an extended period of time, remove the battery.
- Do not dispose of battery in fire, battery may explode or leak.
- Danger of explosion if battery is incorrectly replaced.
Caution:
This set-up is for charging the rechargeable battery of the Speaker only.
Do not operate the Speaker with this set-up near Water and Moisture environment.
Charging the main unit rechargeable battery with Sun Light
The embedded Solar Panel will charge the rechargeable battery when operating outdoors in a
sunny area.
Embedded Solar Panel

Installation

Advertisement

Table of Contents
loading

Table of Contents