Installation - Pyle Aqua SunBlast PWR95S User Manual

Use only Alkaline batteries or rechargeable batteries like those included inside unit.
A battery compartment located at bottom of the unit.
(1) Unscrew the compartment cap counter-clockwise and open it.
(2) For the first time use:
Just remove the insulation tab attached in the battery compartment (if battery is included).
Screw the compartment cap clockwise and close it tight.
To install Rechargeable Batteries: The battery type switch must be slid to the RECHARGEABLE
position. Follow the polarity diagram shown inside the compartment and install 3 x AA (UM-3)
rechargeable type batteries.
Screw the compartment cap clockwise and close it tight.
To install regular Alkaline battery:
In case of regular Alkaline type battery is installed, take out the old battery then follow the
polarity diagram shown inside the compartment and install 3 x AA (UM-3) type fresh batteries.
The battery type switch must be slid to the NON RECHARGEABLE position.
Screw the compartment cap clockwise and close it tight.
Note:
Switch to "RECHARGEABLE" position to charge the rechargeable battery.
Switch to "NON RECHARGEABLE" position when regular type (e.g. Alkaline type) battery is
used.
Caution:
Never switch to "RECHARGEABLE" position when regular battery (e.g. Alkaline type
battery) is installed which will damage the battery or may cause explosion.
Warnings:
- Battery should not be exposed to excessive heat such as sunshine, fire or the like.
- Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Only batteries of the same or equivalent type are recommended to be used.
- If the unit is not to be used for an extended period of time, remove the batteries.
- Do not dispose of batteries in fire, battery may explode or leak.
- Danger of explosion if battery is incorrectly replaced.

Installation

4