Table of Contents
Advertisement
Available languages
Available languages
Instruction manual
• Close the battery compartment cover.
AC operation
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Plug the corresponding end of cord into
the AC socket on the rear of the set.
• Insert the plug into power supply.
Caution:
• When the set is only used with AC or is
not used for 2 weeks or more, please remove
the batteries, to avoid damage to the set from
leakage of batteries.
• Always switch off the unit when not in use.
• Always unplug the appliance from power
supply, when no use long time.
General operations
Power on/off
Press ON/OFF button on the unit or POWER
button on the RC to switch on the unit. Press
this button to switch off the unit.
Electronic volume control
• This unit uses an electronic volume control.
To increase or decrease the loudness of unit,
press respectively VOL.UP/VOL.DN buttons
on the unit or VOL UP/VOL DOWN buttons on
the RC.
• Volume loudness level is indicated in the
LCD display in 30 steps (0 = minimum, 30 =
maximum).
Music equalizer
Press EQ button repeatedly to choose
the desired sound effect according to the
music you are listening to: FLAT (EQ off) =>
CLASSIC => ROCK => POP => JAZZ.
Automatic power off (sleep) function
• This set has a special sleep timer function
which can automatically switch off the unit.
• At any time while the unit is operating
4
(CD player or radio), press SLEEP button
repeatedly to choose the automatic power off
time: 90 min => 80 min => 70 min => 60 min
=> 50 min => 40 min => 30 min => 20 min =>
10 min => OFF.
Bass enhancement
Press BASS button to enhance bass
frequencies. Press the button again to
deactivate the function.
Mute
Press MUTE button to mute the sound.
Press the button again or adjust the volume to
resume sound output.
Radio operation
• Press repeatedly FUNCTION button until
the display shows FM.
• Press and hold NEXT/TUNE-UP button or
BACK/TUNE-DOWN button; the fast scanning
starts. The frequency will continue to change
and will automatically stop when a broadcast
station is received.
• To receive a weak broadcast signal
press repeatedly NEXT/TUNE-UP button or
BACK/TUNE-DOWN button on and adjust the
frequency you wish to receive.
Saving stations to memory
• 30 FM broadcast stations can be stored to
the preset memory.
• During tuner mode, find a desired station.
• Press PROG button on the unit or PROG
button on the RC to activate memory setting
mode.
• Press MEM-/FOLDER- button or MEM+/
FOLDER+ button to choose the desired
memory location. The location number is
flashing on the left side of the screen.
• Press PROG button on the unit or PROG
button on the RC button again to store the
desired station.
• Repeat steps for storing stations to other
locations.
Advertisement
Table of Contents
