Engine Display Set-Up; Warning Screen - Suzuki C10 Configuration Manual

2. Use the arrow buttons to set the fuel capacity
and press Enter.
3. After confirming the Vessel Setup information,
select OK and press Enter.

Engine Display Set-Up

On the Engine Display Setup screen, the C10
defaults Center in the Engine 1 box.
If you are only setting up the C10 for a single
engine, you do not need to make any
changes on this screen.
Select OK and press Enter.

Warning Screen

The C10 uses engine fuel flow to calculate the
remaining fuel in the fuel tank.
1. After completing the configurations above,
a Warning screen asks if any fuel has been
added to the vessel since the vessel was last
used.
If you select Yes, the Add Fuel screen will open.
2. It is recommended that you fill the fuel tank to
full capacity for the initial set-up of the fuel level
display in the C10.
NOTE:
If you desire, you can add a fluid level sensor to the
vessel; then you can add a custom page to the C10
to monitor this information. These procedures are
outlined for you int he following pages. 7