Troubleshooting Guide - DeWalt DCN692 Instruction Manual

English
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
For more serious or persistent problems, contact your nearest authorised D
or contact your D
WARNING: To reduce the risk of serious personal injury, ALWAYS lock off the tool and disconnect
battery pack from tool before all repairs
SYMPTOM
Motor does not run with
trigger depressed
Motor does not run with
contact trip depressed
Tool does not actuate
(motor runs but will
not fire)
Motor starts up but
generates a lot of noise
20

TROUBLESHOOTING GUIDE

WALT office at the address indicated in this manual.
e
CAUSE
Trigger lock in locked position
Tool is stalled, locking the motor from
rotating
Tool is in the sequential actuation mode
Tool internal electronics need to be reset
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged trigger
Battery is hot
Tool is hot
Trigger lock in locked position
Dry fire lock out engaged, blocking
contact trip from traveling fully
Tool is stalled, locking the motor from
rotating
Bent contact trip
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged trigger
Battery is hot
Tool is hot
Dry fire lock out engaged, blocking
contact trip from traveling fully
Low battery charge or damaged battery
Jammed nail/drive blade not returned to
home position
Damaged driver/return assembly
Jammed internal mechanism
Damaged internal electronics
Jammed nail and driver blade is stuck in
down position
Damaged driver/return assembly
WALT repair agent,
e
FIX
Unlock trigger lock.
Rotate the stall release lever on the tool and the
mechanism will release. If driver blade does not
return, remove battery and manually push driver
blade back to home position.
Depress contact trip first before firing or switch to
bump mode (DCN692 only).
Remove battery, wait 3 seconds and reinsert.
Normal operation, release trigger and redepress.
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
Unlock trigger lock.
Load more nails into magazine.
Rotate the stall release lever on the tool and the
mechanism will release. If driver blade does not
return, remove battery and manually push driver
blade back to home position.
See authorised D WALT repair agent.
e
Normal operation, release contact trip and
redepress.
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
Load nails into magazine.
Check charge level if pack shows state-of-charge.
Charge or replace battery pack if necessary.
Remove battery, clear jammed nail, cycle stall
release lever, (push driver blade up manually if
necessary) reinsert battery pack.
Replace driver/return assembly. See authorised
D WALT repair agent.
e
See authorised D WALT repair agent.
e
See authorised D WALT repair agent.
e
Use stall release lever, clear any jammed nails, and
return driver blade manually if necessary.
Replace driver/return assembly. See authorised
D WALT repair agent.
e