Battery Pack; Storage Recommendations; Package Contents - DeWalt DCN692 Instruction Manual

18v xr li-ion cordless framing nailer
Hide thumbs Also See for DCN692:
Table of Contents

Advertisement

English

Battery Pack

BATTERY TYPE
The DCN692 and DCN695 operate on an 18 volt
battery pack.
The DCB180, DCB181, DCB182, DCB183,
DCB183B, DCB184, DCB184B or DCB185 battery
packs may be used. Refer to Technical Data for
more information.

Storage Recommendations

1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not in use.
2. For long storage, it is recommended to store a
fully charged battery pack in a cool, dry place
out of the charger for optimal results.
NOTE: Battery packs should not be stored
completely depleted of charge. The battery pack will
need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack may
show the following pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Battery charging.
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced
immediately.
12
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care
for the environment.
Charge D
WALT battery packs only with
e
designated D
battery packs other than the designated
D
WALT batteries with a D
e
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.

Package Contents

The package contains:
1 Nailer
1 Charger (P2 models only)
2 Battery packs (P2 models only)
1 No-mar tip
1 Kitbox (P2 models only)
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (Fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
A. Trigger
B. Trigger safety lock-off
C. Contact trip
D. Depth adjustment wheel
E. Low battery and jam/stall indicator light
F. Stall release lever
G. Magazine
H. Pusher latch
I. Mode selector switch
J. Rotating rafter/belt hook
K. On-board hex wrench
L. Battery pack
M. No-mar tip
WALT chargers. Charging
e
WALT
e

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcn695Xr li-ion dcn692Xr li-ion dcn695

Table of Contents