Electrolux T5350 Service Manual page 65

Remove the screws and remove the outer sealing plate.
Cut loose the rear sealing from the inner sealing plate.
Put glue on the inner sealing plate and fasten the new rear sealing on the inner sealing plate. The rough side shall be
fastened to the glue.
Remount the outer sealing plate and fasten the screws.
Remount the RMC with arm.
Fasten the bolt and the washer and remount the bearing house. Use tightening torque 20 Nm ± 3 Nm.
On machines with RMC; pull the RMC flange back in position and tighten the screw. Use tightening torque 5 Nm ±
0.5 Nm.
Fasten the belt and make sure the belt is in position. Fasten the belt tensioner.
Remount the rear panel and the top panel.
Service Manual
65
fig.7902
fig.7903