Philips DVP5388K User Manual page 31

[ Center Speaker ] / [ Rear Speaker ]
•
Option
[ Large ]
[ Small ]
[ Off ]
• [ Subwoofer ]
Option
[ On ]
[ Off ]
[ Speakers Volume ] – Set the volume
•
level of each speaker to get the ideal
audio balance.
1. Press OK.
2.
Select a speaker, then press
adjust the volume.
3. Press OK to confi rm and exit.
EN
32
Description
Produce low frequency
signal below 120 Hz.
Cannot produce low
frequency signal below
120 Hz.
No speaker is
connected.
Description
A subwoofer is
connected.
No subwoofer is
connected.
b B to
[ Speakers Delay ] – Set the delay time
•
for the centre, subwoofer and rear
speakers if they are placed closer to the
listening position, so that the sound
output from all speakers reach the
listening position at the same time.
1. Press OK.
2. Select a speaker, then press
set the delay time.
3. Press OK to confi rm and exit.
Note
•
[ Speaker Setup ]
setting is only available if you have
set the [ Analog Output ] setting to [ Multi Channel
].
[ CD Upsampling ]
For better sound quality in stereo mode,
convert the music CD to a higher sampling
rate.
[ Off ]
• – turn off CD-upsampling.
• [ 88.2kHz (X2) ]
original sampling rate.
[ 176.4kHz (X4) ]
•
times the original sampling rate.
[ Night Mode ]
You can play DVDs with Dolby Digital
mode at a low volume, without disturbing
others. High volume output is decreased
and low volume output is increased to an
audible level.
[ On ]
• – turn on night mode.
[ Off ]
• – enjoy surround sound with its
full dynamic range.
b B to
– convert to twice the
– convert to four