Philips DVP5388K User Manual page 30

[ Analog Output ]
Select the analogue audio setting based on
the audio device that is connected through
the analogue audio socket.
• [ Stereo ] – for stereo output.
• [ LT/RT ] – for surround sound output
through two speakers.
• [ Multi Channel ] – for multi channel
output.
[ Digital Audio Setup ]
Select the setting based on the digital
amplifi er/receiver that is connected
through the digital socket.
[ Digital Output ]
• – select the type of
digital output.
Option Description
[ Off ] Disable digital output.
[ All ] The device supports
multi-channel audio
formats.
[ PCM Only ] The device is not capable
of decoding multi-channel
audio. Audio is
downmixed to two-
channel sound: see
LPCM Output ]
[ LPCM Output ]
• – select the LPCM
(Linear Pulse Code Modulation) output
sampling rate.
Option Description
[ 48k ]
For discs recorded at
sampling rate of 48 kHz.
[ 96k ] For discs recorded at the
sampling rate of 96 kHz.
•
[ Digital Audio Setup ]
[ HDMI Audio ] is set to [ Off ].
•
[ LPCM Output ]
[ Digital Output ] is set to [ PCM only ].
•
The higher the sampling rate, the better the sound
quality.
[ HDMI Audio ]
Select the audio output setting when you
connect this DVD player and the TV with
a HDMI cable.
•
•
[ Sound Mode ]
Select a preset sound effect to enhance
the audio output.
•
•
•
[
[ Speaker Setup ]
setting.
When you connect a speaker system, you
can optimise surround output for the
connected speakers.
•
Option
[ Large ]
[ Small ]
Note
setting is only available if the
setting is only available if the
[ On ] – audio output through the TV.
[ Off ] – disable audio output from the
TV.
[ 3D ] – select a virtual surround sound
effect that is produced from the left and
right audio channels.
[ Movie Mode ]
– select a sound effect
for movies.
[ Music Mode ] – select a sound effect
for music.
[ Front Speaker ]
Description
Produce low frequency
signal below 120 Hz.
Cannot produce low
frequency signal below
120 Hz.
EN
31