Dometic BR342 Installation And Operating Manual page 11

INSTALLATION INSTRUCTIONS
FIG. 9
Duct Divider
111.1mm From Back
Of Roof Opening
6. Ceiling Template Installation
a. Plug the 6 pin electrical cord from the top unit
into the matching 6 pin connector in the elec-
tronic control box. The plug is polarized and
ZLOO RQO\ ¿W LQ RQH GLUHFWLRQ 6HH (FIG. 10).
FIG. 10
Unit Electrical
Cord
b. Route the previously run 240 Vac power sup-
ply wire through the junction box hole cutout.
See (FIG. 10).
c. Secure 240 Vac power supply using the sup-
plied strain relief. Install strain relief in junc-
tion box hole leaving enough wire inside
junction box to connect unit wires to power
supply wires. See (FIG. 10).
d. Hold the ceiling template up to the roof open-
ing and line up the channel in the ceiling
template with the previously installed duct
divider. See (FIG. 11).
Base Pan
Front
Black Side
Rear
To Front
Plastic
Strain Relief
FIG. 11
e. Hold the ceiling template up to the roof open-
ing and start each mounting bolt, by hand,
through the ceiling template and up into the
unit base pan. See (FIG. 12) & (FIG. 13).
FIG. 12
Mounting Bolt Pattern Table (See Fig. 14)
Model
BR36H70CR
A
FIG. 13
E F
7
Duct Divider
Mounting Bolt
Mounting Bolt
Bolt Location
A, D, E & H
C
B D
G H
Channel