Phone Set-Up; Getting Started Installation; Installation - apivio UT880 Admin Manual

Manual

3. Phone set-up

In addition to typical phone features, UT880 has a wide variety of features. Correct setup values should be entered
in order to properly access to the Internet phone service server and make the most of such diverse features.
For this, UT880 provide Android based Application for setting up the phone.
All features can be set with the Application.
Reference
UT880 only provides Android based Touch Screen Panel and does not provides WEB UI.

3.1 Getting Started Installation

3.1.1 Installation

Before installing UT880, the safety cautions specified in the beginning of this manual should be carefully read and
understood. Then, a proper installation place shall be selected.
1 Connect the Ethernet cable to the LAN port. (When a handset is to be used with a PC, the PC's Ethernet cable
should be connected to the handset's LAN connection port while the PC is connected to the handset's PC
connection port.). The LAN connection connector is a RJ-45 type, and the Ethernet cable is a UTP cable
(Category 5).
2 Connect the two ends of the Ethernet cable to the PC and the PC connection port.
3 UT880 is PoE enabled device, so this doesn't provide power adaptor and DC power jack.
Once phone booting is completed, the phone will try getting IP address from DHCP server.
UT880 factory default is set to use DHCP, so if there is a designated DHCP server on user's network, IP address
will be automatically assigned. However, if there is no DHCP, an available static IP should be requested to and
assigned by a network administrator
14
User
UT880