Page 1
QUICK
S TART
G UIDE
For
l atest
i nfo,
t ips,
a nd
p hotos
g o
o nline
t o:
...
Page 2
a nd
a
b etter
l ife!
We
e ncourage
y ou
t o
g o
o nline
t o
w ww.dogPACER.com
t o
s ee
o ther
...
Page 3
2.0 Attach the Overhead Bar Put the overhead bar into place using the 4 M6*15 screws. NOTE:Please insert all the screws initially and tighten one by one using the 5mm Hex Key. Do not over tighten. ...
Page 4
4.0 Attach side panels 1. When the dogPACER is in position, lay the side panel down on the belt. Insert the side panel to the rubber clips (A, B & C) on the P.V.C. side rails. 2. Put the upper part of the side panel under the fixed clip on upper bar (see diagram below).
Page 5
1. Start the treadmill by pushing the start/stop button. 2. At minimum speed, go to the back of the dogPACER and see if the running belt stays in the middle. If it shifts to the right or left do the following: If
...
Page 6
dogPACER
p rovides
t echnical
s upport.
P lease
w rite
a n
e mail
t o
–
For
f urther
i nformation
a nd
h elp
p lease
s ee
U SER’S
M ANUAL
o r
f or
F AQ’s
a nd
...
Need help?
Do you have a question about the MINIPACER and is the answer not in the manual?
Questions and answers