Table of Contents
Advertisement
connection, WLAN-2 if you are using the second card, e.g. as with an access
point with two WLAN modules).
When set as P2P Master, the passphrase entered here will be used to check
the Slave's authorization to access. When set as P2P Slave, the access point
transfers this information to register with the remote site.
Configuration with
For configuration with LANconfig you will find the encryption settings under
LANconfig
the configuration area 'Wireless LAN' on the '802.11i/WEP' tab.
The encryption settings for the individual logical WLAN networks can be
Configuration with
WEBconfig or Telnet
found under WEBconfig or Telnet under the following paths:
Configuration tool
WEBconfig
Terminal/Telnet
LANCOM OAP-54-1 Wireless – LANCOM OAC-54-1 Wireless
Activate the 802.11i encryption.
Select the method '802.11i (WPA)-PSK'.
Enter the passphrase to be used.
The passphrases should consist of a random string at least 22 charac-
ters long, corresponding to a cryptographic strength of 128 bits.
Menu/Table
Expert configuration
faces
/Setup/Interfaces/WLAN-Interfaces/Encryption-Set-
tings
Chapter 5: Advanced wireless LAN configuration
Setup
Interfaces
Encryption-Settings
WLAN-Inter-
57
Advertisement
Table of Contents
