Table of Contents
Advertisement
LANCOM OAP-54-1 Wireless – LANCOM OAC-54-1 Wireless
Chapter 2: Installation
22
Wireless please observe the information on lightning protection in the
attached LANCOM Outdoor Wireless Guide.
Optional: Antenna terminal LANCOM OAP-54-1 Wireless – screw the sup-
plied diversity antennas onto the two N connectors on the bottom side of
the LANCOM OAP/OAC-54-1 Wireless.
When assembling separately purchased mobile radio antennas please
note that the maximum allowed transmission power of the wireless
LAN according to EIRP in the country in question may not be
exceeded. The system operator is responsible for adhering to the
threshold values.
The employment of the AirLancer Extender SA-5L for internal light-
ning protection is essential under all circumstances—the
AirLancer Extender SA-5L is always mounted between the Access
Point and the antenna, preferably as near as possible to the antenna.
Antennas are only to be attached or changed when the device is
switched off. Mounting or demounting antennas while the device
switched on may cause the destruction of the WLAN module!
LAN—The LAN connector is also used to supply power to the LANCOM
OAP/OAC-54-1 Wireless. Plug in the water-proof power cable to the LAN
port on the underside of the device and carefully tighten the threaded
connector. Connect the other end of the power cable to the 'Power Out'
connector on the supplied PoE Injector.
DSLoL – If you want to use your access point in DSLoL mode, you can
either connect the device directly to the DSL modem (exclusive mode) or
to a hub resp. switch of the cable-bound LAN (automatic mode).
For the exclusive mode insert the included network cable (green
plugs) into the LAN connector of the device and the other end into the
corresponding interface of the DSL modem.
For the automatic mode for simultaneous operating with LAN and
DSLoL insert the included network cable (green plugs) into the LAN
connector of the device and the other end into a free network con-
necting socket of your local network (resp. into a free socket of a hub/
switch).
Advertisement
Table of Contents
