Nibe F1255 Installer Manual page 56

Remove the connection from the base card (AA2)
5
using a screwdriver.
Disconnect the connectors (A) and (B) from the un-
6
derside of the base card cabinet.
Disconnect the connector (C) from the immersion
7
heater circuit board (AA1) using a screwdriver.
Disconnect the connector (D) from the joint circuit
8
board (AA100).
Carefully pull out the cooling module.
9
TIP
The cooling module is installed in reverse order.
56 Chapter 9 | Service
5
8
6
D
A
B
9
7
C
NOTE
At reinstallation, the supplied O-rings must re-
place the existing ones at the connections to
the heat pump (see image).
F1255
5
USB service outlet
The display unit is equipped with a USB socket that can
be used to update the software, save logged information
and manage the settings in F1255.
F1255
QM33
QM34 QM32
NIBE™ F1255