Changing The Base Runner - Festool OF 2200 EB Instruction Manual

14
– Release the lever [17.4] again.
– Insert a copying ring [17.3] in the correct position
on the router base.
– Insert the tabs [17.2] on a base runner into the
router base.
– Push down the base runner until it engages in
the router base.
The overhang Y of the workpiece in relation the
template is calculated as follows:
Y = ½ (diameter of copying ring minus diameter of
routing bit)
c) Edge trimming
Routing tools with a bearing guide are required
when the machine is used for edge trimming. The
machine is then guided in such a way that the bear-
ing guide rolls off the workpiece.
When trimming edges, always use the chip defl ec-
tor KSF-OF to improve dust extraction.
d) Routing with a guide system FS
The guide system (partly as an accessory) makes
it easier to route straight grooves.
19.1
19.2
19.3
– Secure the guide rail to the workpiece using
clamps [19.4].
– Insert the base runner [19.3] for the guide stop
into the router base (see "Changing the base
runner").
 This base runner is offset to compensate for the
height of the guide rail.
– Secure both guide rods [19.6] with the rotary
knobs [19.5] and [19.9] on the guide stop.
– Unscrew the rotary knob [19.1].
– Insert the guide rods [19.6] into the grooves on
the router base.
– Place the router with the guide stop on the guide
rail.
– If required, you can adjust the play of the guide
stop on the guide rail by adjusting the two guid-
ance jaws [19.2] with a screwdriver.
– Slide the router along the guide rods until the
routing tool reaches the required distance X from
the guide rail.
– Screw up the rotary knob [19.1].
– Unscrew the rotary knob [19.10].
– Turn the adjusting wheel [19.7] to adjust distance
X more precisely.
 Hold the adjusting wheel [19.7] to turn the scale
[19.8] independently to "zero".
– Screw up the rotary knob [19.10].

Changing the base runner

Festool offers special base runners (as an acces-
sory) for different applications.
Change the base runner as follows:
20.1
19.10
19.9
19.8
20.2
19.7
19.6
19.5
20.3
– Lay the machine on its side on a stable base.
19.4
– Open the lever [20.3].
– Remove the base runner [20.1].
– Release the lever [20.3] again.
– Insert the tabs [20.2] on a base runner into the
router base.
– Push down the base runner until it engages in
the router base.