Settings; Tool Holder, Attachments - Festool CXS Instruction Manual

Charger wall mount
The charger MXC has two elongated holes on its
back. It can be mounted on a wall using two screws
(e.g. round head or flat head screw with shank di-
Consider the pictures on the fold-out page.
Changing the direction of rotation
The right/left switch [1-5] changes the direction of
rotation.
• Move switch from right to left = clockwise rota-
tion
• Move switch from left to right = anticlockwise ro-
tation
Changing gear
 Always switch off the machine before changing
gear!
You can change gear using the gear switch [1-4].
• Switch forwards (Number 1 visible) = first gear
• Switch backwards (Number 2 visible) = second
gear
WARNING
Risk of injury

Make sure that the machine is switched off and
the battery pack has been removed before
changing the tool holding fixure, attachments
and tools.
12
ameter of 5 mm) (see Fig. Fig. [5]).
5

Settings

By turning the torque thumbwheel [1-1] the re-
quired torque can be adjusted. The arrow [1-3]
aligns with the adjusted state.
Drilling
Turn the torque thumbwheel [1-1] so that its
marking [1-3] faces the drilling symbol [1-2]. Max-
imum torque is set in this position.
Fastening
Adjust the torque accordingly at the torque thumb-
wheel [1-1]:
Position 1 = low torque
Position 12 = high torque
The machine switches off when the present torque
is reached. The machine only continues running
when the on/off switch [1-6] is released and
pressed again.

Tool holder, attachments

The tool chuck CENTROTEC WH-CE allows you to
change tools with a CENTROTEC shank in a matter
of seconds.
 Always use a CENTROTEC tool chuck to clamp
3 mm
85 mm
(3 11 32 '')
Adjusting torque
Tool chuck CENTROTEC WH-CE