Festool CXS Instruction Manual page 11

Inserting the battery pack

Slide the battery pack upwards into the machine
like shown in Fig. [2] until it engages.
Changing side of the belt clip
Fix the belt clip [3-1] on the right or on the left side,
depending on which side you prefer to clip the cord-
less drill.

Remove the battery pack Fig. [2].

Remove the belt clip [3-1].

Insert the belt clip on the side.

Insert the battery pack Fig. [2].
3-1
3
Charging the battery pack [Fig 4]
 The battery pack is delivered partially charged.
Charge the battery pack completely before us-
ing for the first time.

To charge the battery pack, put it on the retainer
[4-1] on the charger.

To remove, pull off the charged battery pack.
4
The charger MXC can be used to charge all Festool
battery packs of the BP-XS series.
The LED [4-2] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack will be charged with max. current.
LED green - flashing slowly
Battery Pack is charged to 80 % and will be charged
with further reduced current.
LED green - lit continuously
Battery pack is fully charged.
LED red - lit continuously
Battery temperature is outside the permitted range
(0 °C to 45 °C).
LED red - flashing
General fault display, e. g. incomplete contact,
short circuit, battery pack faulty, etc.
4-1
4-2
11