View Day Average Results - ULTICARE IPET PRO User Manual

View Day Average Results

1. Press to turn the meter on and
select a desired animal type, then
press the button to view day
average results.
2. 7/14/30 day average results
marked with a no meal/ pre-
meal/ post-meal will be displayed
on the screen in sequence
when the button is
pressed (Fig.43-50).
3. When the meter displays 7 days
with no meal status assigned,
press the button and the
meter will change to view stored
test results in memory.
22
Note:
1. The consecutive 7/14/30
day average is calculated from
the test results obtained during
the last consecutive 7/14/30
day periods.
2. A result with a symbol indicates
that the reading was taken out of
(Fig.43)
(Fig.47)
the meter's specified operating
temperature range and may
not be accurate. This value is
excluded from the 7/14/30 day
average.
3. "LO" under 20 mg/dL
(1.1mmol/L) and "HI" over 600
mg/dL (33.3mmol/L) readings will
NOT be stored in the memory.
(Fig.44) (Fig.45)
(Fig.48) (Fig.49)
(Fig.46)
(Fig.50)