Gimbal Control - X-cam A22-3H User Manual

BEEP BEEP will be shouted after the connection succeed, the parameters will be read out automatically.
The parameters as below:
1. Gains
There are 2 gains, Position Gain and Acceleration Gain
Pos. Gain: Inclined the gimbal to one position slowly and watch the image is horizontal or not, if not just adjust the Pos. Gain.
Acc. Gain: After adjusting the Pos. Gain, Inclined the gimbal to one position quickly and watch the image is horizontal in time, if not just
adjust the Acc. Gain.
Notice: the A10-3H has been finished the adjusting, does not need to adjust again in
       
2.

Gimbal Control

The A10-3H provides 2 ways to control the TILT, Linear Mode or Tracking Mode
Linear Mode: Push the TILT stick to high or low for moving the camera mount to up or down until the stick back to midpoint
Tracking Mode: Push the TILT stick to high or low, the camera mount will follow the stick position.
Push speed: Setup the camera mount moving speed, high value set high speed; low value set low speed.
normally