Removing An Sfp Module; Connecting Devices To The Ethernet Ports - Casio Catalyst 3750-E Installation Manual

Chapter 2 Switch Installation
Figure 2-23

Removing an SFP Module

To remove an SFP module from a module slot, follow these steps:
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2 Disconnect the cable from the SFP module. For reattachment, note which cable connector plug is send
(TX) and which is receive (RX).
Step 3 Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 4 If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch.
Grasp the SFP module, and carefully remove it from the module slot.
Step 5
Place the removed SFP module in an antistatic bag or other protective environment.
Step 6

Connecting Devices to the Ethernet Ports

This section includes these topics:
•
•
Category 5e and Category 6 cables can store high levels of static electricity. Always ground the cables
Caution
to a suitable and safe earth ground before connecting them to the switch or other devices.
OL-9774-04
Installing an SFP Module in Catalyst 3560E-12SD Switches
10/100/1000 Ethernet Port Connections, page 2-26
PoE Port Connections, page 2-26
Catalyst 3750-E and Catalyst 3560-E Switch Hardware Installation Guide
Connecting Devices to the Ethernet Ports
2-25