Table of Contents
Advertisement
Connecting the DVD recorder
5
Switch on the TV set.
6
Insert one end of the supplied mains cable into the mains socket
4MAINS at the back of the DVD recorder and the other end into
the wall socket.
7
A message appears on the screen announcing that the transfer has
started. '
' appears on the display during transfer.
The TV set transfers all saved TV channels, in the same order, to the
DVD recorder.
This may take several minutes.
a
Normally the date and time are taken from the data sent by the TV
channel stored on programme P01. If th aerial signal is too weak or there
is excessive interference, you should set the date and time manually:
1
Check if the time in '
2
If required, change the time with the number buttons 0..9 on your
remote control.
3
Select the next line with CH+ A or CH- B .
4
Check if the displayed settings for '
correct.
5
When all information is correct, save by pressing OK .
a
Not all the necessary data has been transferred. Please enter the settings
by hand as follows. For more information on the various functions see
'Initial installation' in 'Installing your DVD recorder'.
1
Select the desired audio language using CH- B or CH+ A and confirm
with OK .
2
Select the desired subtitle language with
confirm with OK .
3
Select the desired screen format position using CH- B or CH+ A .
'
'
'
'
'
'
For a 16:9 TV set
4
Confirm with OK .
5
Select the country of your residence with CH- B or CH+ A .
If your country does not appear, select '
6
Confirm with OK .
Initial installation is now complete.
' is correct.
', '
CH- B or
For a 4:3 TV set; cinema format (black bars above and
below the picture)
For a 4:3 TV set; full height format with the sides cut
off
'.
' and '
' are
CH+ A and
Advertisement
Table of Contents
