Rack Installation; Installing The Board Module - OSEE HMV160 User Manual

2.4 Rack Installation

Install the frame to the rack.
Via the ear holder on both sides of the frame, install the HMV160 frame into a standard 19" rack,
using the proper screws and washers, which are not included in the packing list.
For proper ventilation, make sure the air vents of the side panel and top panel are not blocked.

2.5 Installing the Board Module

Static electricity may cause sensitive semiconductor out of order. Avoid installing
Caution：
or removing the module in the electrostatic-induced environment.
Follow the next steps to install the module:
Step 1: Open the front panel of the frame, as shown below:
In order to open the front panel, firstly push the two orientation locks inward, as shown
below.
Secondly pull it out to remove the fan section, as shown below.
Step 2: Locate the position for back connector and insert the back connector.
HMV160 High-definition Multi-viewer Display Processor
-6 -
User Manual