Making The Connections; Removing The Board Module - OSEE HMV160 User Manual

Step3: Fasten the screws to fix the back connector.
Step4: Locate the slot for module.
Step 5: Get the module installed in the slot, push the module slightly along the slot, press module
again to confirm that the module is installed firmly and then close swivel handle.
Step6: Install the front panel.

2.6 Making the Connections

Please connect signals based on chapter 3.
Notes: while connecting the cables, please pay attention to the cable weighs so as to avoid the damage to
the back connector.

2.7 Removing the Board Module

Follow the following steps to remove board module:
HMV160 High-definition Multi-viewer Display Processor
Fig. 2-1 Installation of 3RU Frame of HMV160 Series
-7 -
User Manual