Diagnostics And Testing - Viking RDSOE306SS Service Manual

Diagnostics

Diagnostics and Testing

To enter Built-in Test mode, first enter the Settings mode.
Press and hold the "PROBE TEMP" key. You will hear 3 beeps. Continue holding for five seconds, until the relay
board signals one confirmation beep.
Then press within five seconds "START TIME", then "PROBE TEMP", then "START TIME".
When you have successfully entered the Diagnostic mode, the display will show the TOD2 software version
number (currently Version 11, shown below on left).
Note: Version numbers 4, 5 and 6 will not work with EOC4 versions 19 or higher. Version 9 or higher will
work with EOC4 versions 19 or Higher.
Note: While in the Diagnostic parameter, rotating the "SET kNOB" clockwise or counterclockwise will scroll
through all the testing parameters. When in a particular test, depress "MIN/SEC TIMER" to get back to
Parameter Selection to access other test. Depressing "PROBE TEMP" at this point will exit the test mode.
When you have successfully entered the Diagnostic mode, rotate the "SET KNOB" clockwise. The display will
show the supplied frequency to the oven (60 Hz is shown below).
Rotate the "SET KNOB" clockwise and the display will show EOC4 Upper Oven.
Rotate the "SET KNOB" clockwise again and the display will show EOC4 Lower Oven.
Rotate the "SET KNOB" clockwise to the DISPLAY parameter (below left). Depress "MIN/SEC TIMER" to
activate all elements within the clock (below right). Depress "PROBE TEMP" to exit.
Note: Display test implemented in version 11.
© 2012 Viking Preferred Service
After confirmation beep
2
1
3
16