Cisco GS7000 Installation Instructions Manual page 9

Gainmaker node forward local injection module
Table of Contents

Advertisement

Loosen the screws securing the module.
3
4
Lift the module straight up out of the housing to unplug it.
Note: Pull up on the built-in handle.
To install a module, position it in the desired location and carefully slide the
5
module into its slot until connected to the optical interface board.
Tighten the screws securing the module. Torque screws from 25 to 30 in-lbs (2.8
6
to 3.4 Nm).
7
Carefully reconnect any optical fibers that were removed from the original
module.
Important: Clean optical connectors before reconnecting. Follow recommended
fiber optic cleaning procedures.
8
Close the node housing. Refer to Closing the Housing for complete instructions.
4019330 Rev C
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
WARNING:
Laser light hazard. Never look into the end of an optical fiber or connector.
Failure to observe this warning can result in eye damage or blindness.
FLI Module Installation
9

Advertisement

Table of Contents
loading

Table of Contents