Section 3 Initial Set-Up - Reach Bee8 User Manual

Section 3 Initial Set-up

The Bee8 is configured with a test and configuration IP address from the factory. The first step in integrating it into the
resident IT ecosystem is to connect to it while in its IP Range. To accomplish this, first apply power to the Bee8, and record the
IP address of the front panel of the Bee8, then change the IP address of your computer to the same Range, subnet, and
gateway. Once you have temporarily changed your computer to be on the same "network" as the Bee8, connect an Ethernet
cable between your computer and the Bee8 and type in the IP address of the Bee8 in the address bar of your browser. You
will be presented with the landing page of the Bee8 web interface.
Figure 2. Login Page
Enter admin as the user name, and admin as the password and click the Login button. Once these credentials are accepted
you will be presented with the web interface RECORD page. We will return to this page to explain it further shortly, but for
P a g e | 6 Bee8 User's Manual Reach/BTX