Reach Bee8 User Manual page 36

A string example to start a recording session is:
reach&h0dszreach&h0dtnrc record
reach is the user name
szreach is the password
Please also note that Bee8 will return acknowledgements to all commands, and the feedback can be used to trigger
other commands in the control structure of your code. The Quick Start commands listed below detail the feedback
possibilities the Bee8 will respond.
Serial Control Considerations
Serial commands are sent to the bee8 over an RS-422 or RS-485 connection, as the Bee8 will be returning feedback to
every command sent. The communications, therefore are required to be full duplex. The serial communication
parameters are:
Baud Rate 9600 bps
Word size 8 bit
Parity None
Stop Bit 1
Command Structure Hexadecmal
A string example to start a recording session is:
3c 3c c2 80 00 01 3e 3e where:
3c 3c is the prefix
80 is the record command
Please also note that Bee8 will only return acknowledgements when a command is successfully executed in serial
command mode. All commands listed below detail the acknowledgement feedback the Bee8 will respond.
P a g e | 36
brecord:1&h0d where:
Bee8 User's Manual
tnrc record brecord:1 is the record command string
&h0d is a carriage return
00 01 is the start command
3e 3e is the suffix
Reach/BTX