Preparation Using Ground Coffee; Dispensing Hot Water; Preparing Milk Froth - Siemens TE501501DE Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

Preparation using
ground coffee
This fully automatic espresso machine can
also be operated using ground coffee (not
instant coffee powder)�
Important: Fill the water tank (16) with
fresh water every day. The water tank (16)
should always contain sufficient water for
operating the appliance�
Preparation
1� Open the drawer (4)�
2� Put ground coffee into the drawer
(maximum two level measuring spoons)�
Caution: Do not use whole beans or
instant coffee�
3� Close the drawer (4)�
4� Turn the bottom rotary knob (13) to the
G
symbol
5� Press the start button (10)�
Coffee is brewed and then poured into the
cup�

Dispensing hot water

Risk of burns!
A
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
The milk frother must be cleaned before
drawing hot water�
The appliance must be ready for use.
1� Place a pre­heated cup or glass under
the milk frother outlet (6)�
2� Pull out the milk frother (6) to open it�
The appliance heats up� Hot water runs
out of the milk frother outlet (6) for about
40 seconds�
3� Stop the process by pushing in the milk
frother (6)�

Preparing milk froth

A
Risk of burns!
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
Tip: You can froth the milk first and then
dispense coffee, or froth the milk separately
and pour it onto the coffee�
The appliance must be ready for use.
B
1� Press button
B
Button
flashes and the appliance
now heats up for approximately
20 seconds�
2� As soon as button and LED
up, immerse the milk frother so that it
reaches the bottom of a cup or glass
that is one­third filled with milk.
3� Pull out the milk frother (6) to open it�
Risk of burns!
A
Escaping steam is very hot and may cause
liquids to sputter� Do not touch the metal
sleeve or aim it at anyone.
4� Froth the milk�
5� Push the milk frother (6) in to close it�
Tip: For optimal milk froth, if possible use
cold milk with a fat content of at least 1�5 %�
Important: Dried milk residue is difficult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use�
(11)�
F
lights
en
29

Advertisement

Table of Contents
loading

Table of Contents