Samsung SMX-K40BN Service Manual page 69

8-1-2 Camera Adjustment
Note: When you replace ASSY-CAMERA or PCB BORAD, you need to adjust each part again, due to
the fact that EEPROM remembers the confirmed adjustment value. Therefore,
re-adjustment is necessary for data-saving when replacing.
- The part that needs re-adjustment after replacing Lens Ass'y or PCB BOARD.
Hall
q
Iris
w
Lens 3m
e
Zoom VR Check
r
Auto White Balance (3100K)
t
Auto White Balance (5100K)
y
OIS
u
1. HALL adjust
The camera should be in "E-E" mode (Video Record).
q
Connect the AV cable to Input port of Monitor or TV.
w
After entering the Admin mode, press the OK button in "CAMERA ADJUST" menu.
e
Press the OK button in "HALL" menu.
r
Press the OK button in "YES".
t
"Adjustment completed!" displays after finishing Hall Adjust.
y
2. IRIS level adjust
The camera should be in "E-E" mode (Video Record).
q
Connect the AV cable to Input port of Monitor or TV.
w
After entering the Admin mode, press the OK button in "CAMERA ADJUST" menu.
e
Press the OK button in "IRIS" menu.
r
Press the OK button in "YES" .
t
Adjustment completed!"displays after finishing IRIS Adjust.
y
Samsung Electronics
Alignment and Adjustment
8-3