Advertisement
Quick Links
Advertisement
Related Manuals for IDEAL W60
Summary of Contents for IDEAL W60
- Page 1 W45, W60, W80 & W100 W45P , W60P & W80P...
-
Page 2: Important Notes
Important Notes This appliance must not be operated without • Natural Gas & LPG the casing correctly fitted and forming an adequate seal. PI No. 0063 BN 3218 If the boiler is installed in a compartment then the • 0087 BS 61 (imax W100 only) compartment MUST NOT be used for storage purposes. - Page 3 BOILER CONTROLS / DISPLAY A. Burner switch D. Reset button G . Store button B. Pressure gauge E. Mode button H. + button (to increase values) C. Display F . Step button - button (to decrease values) Operation Sequence Boiler Status DHW valve energised Standby, no heat request Pre-purge, post purge...
- Page 4 CONTROL OF WATER TEMPERATURE AND SYSTEM TYPES The water temperatures and system types are factory preset but may be adjusted. The following settings can be changed. DHW Temperature (optional) DHW System CH System Flow Temperature Parameter settings and limits are listed below. Parameter mode is entered from standby mode by pressing the 'mode' button once.
- Page 5 To shut Down the Boiler C o n d e n s a t e D r a i n 1. For short periods The condensate drain must not be modified or blocked. Set the external controls to OFF. Wait 10 minutes and then Blockage of the condensate drain, caused by debris or freezing, isolate the mains supply to the boiler.
- Page 6 NOTES User's...
- Page 7 NOTES User's...
- Page 8 Hull, HU5 4JN. Telephone: improvement in the design and 01482 492 251 Fax: 01482 448 858. performance of its products. Registration No. London 322 137. The right is therefore reserved to vary specification without notice. Ideal Consumer Helpline Tel: 01482 498 376 www.idealboilers.com...