Attaching A Fiber Optic Strobe - Ikelite 6148.72 User Manual

5. Push the lid snaps toward the housing until they are flat against the
housing and the lock has engaged. Close opposing lid snaps at the
same time.
6. Check the o-ring seal. The o-ring should form a uniform, solid line
around the back of the housing. There will be a small, even gap
around the housing between the housing back and the housing
front.

Attaching a Fiber Optic Strobe

1. Check the end of the fiber optic cord to ensure that it is clean and
smooth.
2. Ensure that the Fiber Optic Cord O-ring is in place. This o-ring
does not provide waterproofing, however it does keep the fiber optic
cord in place.
3. Attach one end of the fiber optic cord into one of the fiber optic
ports on the front of the housing. The connector is a press-fit into
the fiber optic port.
4. Attach the other end of the fiber optic cord to a compatible strobe.
5. Set the strobe to the appropriate setting based on manufacturer
recommendations.
6. Turn the camera on.
7. Turn the strobe(s) on.
10
Fiber Optic Cord
O-ring