Yamaha RX-V3800 Firmware Update Procedure page 2

Instructions for Firmware Update:
Step 1. Unzip the
"RXV3800-0017.bin" into the root directory of the USB flash drive.
Note) DO NOT put more than one firmware "RXV3800-xxxx.bin" file
on the root directory of the USB flash drive, this will cause the
update on the RX-V3800 to not start.
MASTER
Step 2. Confirm that the AC power cable of the Yamaha receiver is plugged to
the wall outlet and [MASTER] button is switched to the OFF position.
Step 3. Press and hold the [STRAIGHT] button behind the front lid and keep it
pressed.
"ADVANCED SETUP" appears on the front display of the receiver,
release the [STRAIGHT] button.
Step 4. Press and hold the [SLEEP] button on the front panel for about 3
seconds, then the "Firmware Update mode" is activated.
Step 5. Select "USB" by rotating the [PROGRAM] knob and press the [SLEEP]
button to get into "update in wait mode".
Step 6. Insert the USB flash drive to the USB terminal located at the front
panel and the writing will start automatically.
Note)It will take 10 seconds before the update begins, the total
process will take about 30 minutes to complete.
Update Start
Firmware Update Procedure for RX-V3800
downloaded content
STRAIGHT
PROGRAM
Then, press [MASTER] button of the unit.
Page.2 of 4
and copy
TUNING MODE
SLEEP
USB
Update Finish
the firmware
When