Vivotek VS8102 User Manual page 66

VIVOTEK
Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, the Preset Position and PTZ Control
Panel on the main page will be disabled. You will need to configure command buttons to control the PTZ
scanner. Click Custom Command to open the Custom Command page to set the commands in the
Control Settings session. Please refer to your PTZ scanner user's manual to enter the commands in the
following fields. Click Save to enable the settings and click Close to exit the page.
►The command buttons will be displayed on the main page:
66 - User's Manual
NOTE
►If you select DynaDome/SmartDOME, Lilin
PIH-7x00, Pelco D, Pelco P, or Samsung
protocol as the PTZ driver, the Control
Settings column will not be displayed.
►For all PTZ drivers, a total of five additional
command buttons can be configured.