Default Bios Setting; Entering Setup; Standard Cmos Features - Kennmex K875 User Manual

8. Insert the media containing the BIOS update software.
9. Follow the screen prompts on the client to update the BIOS. You can select two methods to
run the update program.
• Automatic BIOS Update – update process runs unattended
Note: You will see a prompt for terminal model and serial number information if the
program detects invalid information in the current BIOS, or if you are replacing the
processor board, in which case there is not model/serial number information in the BIOS.
Important: Model/Serial Number is mandatory.
• Interactive BIOS Update – permits you to input/replace the model/serial number
information that is stored in the BIOS.
Note: Model/Serial number data that is currently stored in the BIOS is displayed during
power up.
10. You should see a green window, indicating a successful update.
11. Disconnect the keyboard and remove the media before the system reboots.
Note: If the keyboard is disconnected while the terminal is powered on the MSR will no
longer function. You must power cycle (cold boot) the terminal to reset the MSR function.

8. Default BIOS Setting

Entering Setup

1. Connect an alphanumeric USB keyboard to the terminal.
2. Apply power to the terminal.
3. At the prompt at the bottom of the screen press
BIOS Default Values

Standard CMOS Features

System Date
System Time
Video
Halt On
[Del]
(variable)
(variable)
[EGA/VGA]
[All , But Keyboard]
31
to enter setup.