Table of Contents
Advertisement
Ring/Alert Volume
Set speaker volume for SIP ring event. This setting is an amplifier
gain control and the output level will also depend on the levels
recorded into the source WAV file played from memory. This setting
is only used for local tones, and not when receiving multicast (see
Page Speaker Volume below).
Caution: The 8186 SIP Horn Speaker is capable of output levels
in excess of 120dB at 1 meter. Ensure nobody is in close
proximity to the horn, especially during installation and testing
of the product.
Ring Limit
Typically set to no limit, this feature can be used to set a limit on how
long the speaker will ring before timing out. A new ring event is
required before the speaker will play the WAV file again.
Page Speaker Volume
Speaker page volume control for SIP or multicast paging. This setting
is an amplifier gain control and output level will depend on streaming
level. This setting will apply to all multicast, regardless of content.
Page Mode
A call to the SIP page extension can be one way, two way using the
integrated microphone, or delayed. In delay mode, the speaker will
store the page into memory and then play after disconnect.
Page Timeout
A time limit may be set for an active page.
Page Tone
Select pre-announce tone for paging.
G.722 Support
Enable or disable the G.722 codec.
Document 90-00079
2016-12-08
Page 25
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker
(604) 454-3792
support@algosolutions.com
Hide quick links:
Advertisement
Table of Contents
