Emerson Vission 20/20 Operation And Service Manual page 208

Appendix B • Vission 20/20 Application Procedures
Step 2: Selection and Naming of Auxiliary Analog
Outputs used for Level Control
Navigate to page 5 of the Confi guration screen and se-
lect the analog output(s) that will be used modulating
the positioning valve(s) on the vessel(s). Also provide
a name for the analog output(s). You'll need to refer-
ence your wiring diagram to determine which analog
output(s) need to be enabled.
Figure B-30. Enabling and Naming Analog Outputs (Confi guration Screen – Page 5)
B - 52
In the example in Figure B-30, Auxiliary #1 Analog
Output was renamed to "Chiller Level 4,20 Out" and
Auxiliary #2 Analog Output was renamed to "Condenser
Level 4,20 Out". Referencing the wiring diagram, please
note that Aux #1 Analog Output corresponds to AO#5
on the wiring diagram, and Aux #2 Analog Output cor-
responds to AO#6 of the wiring diagram.
Vission 20/20 • Operation and Service Manual •Vilter/Emerson • 35391SC 2.0