Emerson Vission 20/20 Operation And Service Manual page 188

Appendix B • Vission 20/20 Application Procedures
USING THE DEVICE AS A NETWORK ISOLATOR/
REPEATER
(Reference Figure B-17)
1. A DC power supply is required to power the device
( +10vDC to +30vDC)
2. Dip switches on each side of the device must be
confi gured for the baud rate of the network.
Figure B-17. Wiring Diagram – VPN3485MS Device as Network Isolator/Repeater
B - 32
Table B-2. Baud Rate Selection
Vission 20/20 • Operation and Service Manual •Vilter/Emerson • 35391SC 2.0