Table of Contents
Advertisement
3.3.2 Mounting Instructions
1. For a tight grip, the mounting surface should be cleaned of dirt and oil.
2. If the mounting surface cannot be used with the suction cup, it may be possible to use the
base plate to create an appropriate surface. If so, use the adhesive on the base plate to
attach the plate to the mounting surface. (Note that the adhesive on the base plate is
difficult to remove once it is mounted.)
3. Place and press the suction cup against the mounting surface or base plate. While
maintaining pressure, push on the lever near the suction cup until the suction cup grips the
surface tightly.
4. Adjust the swivel/tilt arms by loosening the adjustment nuts and turning the swivel cradle to
obtain the best viewing and GPS reception position. Then tighten the nuts to hold the arm
in place once it is snapped into the slop of the unit.
Windshield Mounting Position
3.3.3 Disassembling the Mounting System
•
To remove the suction cup from the mount surface, push the level near the suction cup in the
opposite direction from that used to attach it and pull on the suction release tab to break the
vacuum seal.
•
To remove the unit from the suction cup mount, release the clip and slide the clip to the wide
portion of the slot.
Caution: Be sure to check the adhesiveness of the suction cup every time the mounting system is
used. Aging and temperature fluctuation inside a car will eventually loosen the seal of the suction
cup. A loose seal could allow the N-380 to fall.
10
Copyright© 1998-2008
N-380 User Manual
08/18/2008 V1.0
Dashboard Mounting Position
ProGin
Advertisement
Table of Contents
