Technical Data; Installation - Zanussi ZRA226CWO User Manual

Replacing the lamp
Caution! Before replacing the lamp, disconnect
the appliance from mains power supply.
Lamp specification: 220-240 V, max. 15 W
Follow below process to replace the lamp:
1. Set the temperature regulation knob at number "0"
to switch off the appliance.
2. Unplug the appliance to ensure it is disconnected
from main power supply.
3. Remove the screw of the lamp cover.
4. Pull the lamp cover out.
5. According to the direction shown in below picture,
unscrew the lamp.

Technical data

For further technical information please refer to the
rating on the internal left side of the appliance and in
the energy label.

Installation

Read the Safety information carefully for your
safety and correct operation of the appliance
before installation.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate class
SN
N
ST
T
18
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
6. Fit new lamp in anti-clockwise direction, then
replace the lamp cover and screw.
7. Plug in the appliance and regulate the knob to
correct position.
1
2
3
1
Lamp
2
Screw
3
Lamp cover
Dimensions
Height
Width
Depth
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely around
the back of the cabinet. To ensure best performance,
if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top
of the cabinet and the wall unit must be as least
100 mm. Ideally, however, the appliance should not
be positioned below overhanging wall units. Accurate
levelling is ensured by one or more adjustable feet at
the base of the cabinet.
Warning! It must be possible to disconnect !the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation
1,440 mm
554 mm
570 mm