Daily Use; Environmental Protection - Zanussi ZRA226CWO User Manual

250l
Hide thumbs Also See for ZRA226CWO:
Table of Contents

Advertisement

Available languages

Available languages

Warning! Any electrical component (power cord,
plug, compressor) must be replaced by a certified
service agent or qualified service personnel.
1.
Power cord must not be lengthened.
2.
Make sure that the power plug is not squashed or
damaged by the back of the appliance. A squashed
or damaged power plug may overheat and cause
a fire.
3.
Make sure that you have access to the mains plug
of the appliance.
4.
Do not pull the mains cable.
5.
If the power plug socket is loose, do not insert the
power plug. There is a risk of electric shock or fire.
6.
You must not operate the appliance without the
cover on the interior light
This appliance is heavy. Care should be taken when
moving it.
Avoid prolonged exposure of the appliance to direct
sunlight.

Daily use

Do not put hot objects on the plastic parts in the
appliance.
Do not store flammable gas and liquid in the
appliance, because they may explode.
Appliance manufacturer's storage recommendations
should be strictly adhered to. Refer to relevant
instructions.
Care and cleaning
Before maintenance, switch off the appliance and
disconnect the mains plug from the mains socket.
Do not clean the appliance with metal objects.
Regularly examine the drain in the refrigerator for
defrosted water. If necessary, clean the drain. If the
drain is blocked, water will collect in the bottom of
the appliance.
Installation
Important! For electrical connection carefully follow the
instructions given in specific paragraphs.
Unpack the appliance and check if it is damaged.
Do not connect the appliance if it is damaged. Report
possible damages immediately to the place you
bought it. In that case retain packing.
It is advisable to wait at least four hours before
connecting the appliance to allow the oil to flow back
in the compressor.
Ensure adequate air circulation around the appliance,
otherwise it may overheat. To achieve sufficient
ventilation follow the instructions relevant to
installation.
Wherever possible the back of the product should be
against a wall to avoid touching or catching warm
parts (compressor, condenser) to prevent possible
burn.
The appliance must not be located close to radiators
or cookers.
Make sure that the mains plug is accessible after the
installation of the appliance.
Service
Any electrical work required for servicing of the
appliance should be carried out by a qualified
electrician or competent person.
This product must be serviced by an authorized
Service Centre, and only genuine spare parts must
be used.

Environmental Protection

This appliance does not contain gases which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance
should not be disposed of with urban refuse and
rubbish. The insulation foam contains flammable gases:
the appliance should be disposed of according to the
appliance regulations obtainable from your local
authority. Avoid damaging the cooling unit, especially
at the rear near the heat exchanger. The materials used
on this appliance marked by the symbol
recyclable.
are
13

Advertisement

Table of Contents
loading

Table of Contents