Electrolux WEK 7 Service Manual page 15

6.3.2 Replacing the evaporator
1. Remove rear panel cover (se 2.3.7)
2.
2. Open the rivet head by drilling it out
with a ø6 bit (only the rivet head)
3. Remove the board with the rest of the
rivet
4. Loosen the evaporator screws
5. Warm up the connections with a soldering frame and loosen it
6. Pull the evaporator out of the inside retainer
7. Bend and screw on the new evaporator
8. Lace in the lines, replace the leading-in tube (Art.
No. 126221).
9. Solder the lines in place.
DGS-TDS-N 05.2006 © Electrolux 15 168 650